PDA

View Full Version : Flouro leader to Braid mainline "The Canada Knot"



tangledline
09-26-2012, 10:43 PM
http://www.lindnermedia.com/angling-edge/video/tip-james-lindner-canada-knot#node-850

for the few of us who need an easy knot to tie in the wind or who do not see as well as they did a few decades ago.....or easy knot to learn for the younger angler....

jwm
09-26-2012, 11:45 PM
That's pretty good. It's just two surgeons knots. I've used this loop over loop technique for my fly leaders for a while now, the fly line I have is even tipped with a streamlined loop for this very reason. The only problem is that this probably only scales up to about 30# flourocarbon, after that you start running in to stiffness and problems casting or getting the leader stuck in the eyes of your rod. Also if you're using too light of flourocarbon you risk cutting through it with your braided line.

jwm
09-26-2012, 11:47 PM
These days when I'm attaching flourocarbon leader I use the seaguar knot. It's pretty easy, but the instruction above makes changing leader much easier. I might try it when Im steelheading. You can also pre-tie leaders using the loop technique.

evanxrs
09-27-2012, 08:41 AM
Hey Guys,

I find using a double uni knot of great.

Especially because I usually tie Fluro directly onto braided line.

jwm
09-27-2012, 01:08 PM
To help people visualize I've found videos for each of the knots.

The seaguar knot


http://www.youtube.com/watch?v=2iJ9cMoCsm8

double uni knot


http://www.youtube.com/watch?v=Xk_VUb-dOQo

the "canada knot" or the double surgeons loop


http://www.youtube.com/watch?v=7nt347bANZM

MuskieBait
09-27-2012, 02:27 PM
For lighter braid to lighter fluorocarbon, I use uni-to-uni.

For heavier braid to heavier fluorocarbon, I use the PR knot but instead of melting the fluorocarbon to form a nub to jam the knot, I use a figure 8 knot instead...so in essence it's like a hybrid slim beauty + PR knot. It's slim and pass through larger conventional guides pretty well...and it has stayed strong for me so far. This knot is best when the fluorocarbon diameter is the same or thicker than the braid...which is most of the cases anyways. You do not need to worry about matching the diameter of the line...so you can connect 30lb braid to a 60lb fluorocarbon leader if you need.

cbiegel
09-28-2012, 02:16 PM
Hey Guys,

I find using a double uni knot of great.

Especially because I usually tie Fluro directly onto braided line.

I pretty much use the uni to uni exclusively as well. If I'm using line that's too heavy for that (that would only be in salt water for me), I'll use a wind-on swivel.